Samsung CLP-650 Series - Manual (Page 55)

Solving Problems
7.9
In the Optional Tray2
If paper is jammed in the optional Tray2, a lamp turns on at the
corresponding location on the Status map. Also, “Jam0 In
Tray2” appears on the display.
1
Using the handle, completely open the access door.
2
Open the top cover.
C AUTION :
• Do not touch the fuser inside the inner cover. It is hot and
could cause burns! The fuser’s operating temperature is
180°C (356°F). Take care when removing paper from the
printer.
• Do not touch the green surface, the OPC drum, on the front
of each toner cartridge with your hands or any other
material. Use the handle on each cartridge in order to avoid
touching this area.
• Be careful not to scratch the surface of the paper transfer
belt.
• If you leave the access door open for more than a few
minutes, the OPC drum can be exposed to light. This will
cause damage to the OPC drum. Close the access door
should the installation need to be halted for any reason.
3
Push the levers up.
4
Open the inner cover using the handle on it and carefully
take the jammed paper out of the printer.
5
Close the inner cover and push the levers down. Go to step
14.
If you cannot find the jammed paper, or if there is any
resistance removing the paper, stop pulling and close the
access door. Go to step 6.
The fuser
is hot!