Setting the reception channel – Sony UPW-C1/C2 User Manual
Page 38
Settings
38
4
When the desired channel number
(or frequency) appears, set the
POWER switch to OFF to
complete the setting, or press the
SET button to set other items.
The results are stored in memory.
The stored channel number (or
frequency) will appear in the
display section the next time you
turn on the transmitter by setting
the POWER switch to ON.
Notes
• When you are setting the
transmission channel, the transmitter
cannot be used to transmit signals.
• Do not remove the batteries while
setting the transmission channel. If
they are inadvertently removed, re-
insert them immediately and redo
the procedure “Setting the
transmission channel” from step 1.
• Make sure that the selected channel
is the same on the transmitter and
tuner being used in the same system.
• If you turn off the transmitter and
then immediately turn it on right
after setting the transmission
channel, the unit may not operate
normally. Wait a few seconds before
turning it on again.
Setting the reception
channel
The procedure below is the
same for all UWP series tuners
(URX-P1/R1/M1).
Refer to the pdf files “Sony Wireless
Microphone System Frequency List”
on the supplied CD-ROM for details
on the selectable channel groups and
channels (for the U.S.A. and Europe)
or the supplied leaflet “Sony Wireless
Microphone System Frequency List”
(for Australia).
1
Press down the SET button for
more than one second.
Keep pressing the SET button
until the display section
parameters start to flash.
2
Press the SET button repeatedly
until the channel number (or
frequency) indication appears.
3
Press the + or – button to select
the channel number (or
frequency).
Pressing the + button cycles the
indication in the order shown in
the tables in the pdf files “Sony
Wireless Microphone System
Frequency List” on the supplied
CD-ROM (for the U.S.A. and
Europe) or the supplied leaflet
“Sony Wireless Microphone
System Frequency List” (for
Australia).
Pressing the – button cycles the
indications in the opposite
direction.
Hold down the + or – button to
change the channel number (or
frequency) faster.