Sony UPW-C1/C2 - Manual (Page 37)

37
Group
selection Channel
selection Frequency
selection
V : + button v : – button
Group, channel, and frequency
selection examples for CE62 model are
shown.
Settings
Pressing the – button cycles the
indications in the opposite
direction.
Hold down the + or – button to
change the channel number (or
frequency) faster.
Notes on the European model
The transmission channels are
divided into four sets.
Select the group number before
selecting the channel number as
follows.
1) While the left two digits are
flashing, select the group
number by pressing the + or –
button.
2) When the desired group
number appears, press the SET
button.
The right four digits start to
flash to allow the selection of
the channel number.
3) Select the channel number by
pressing the + or – button.
Setting the
transmission channel
The procedure below is the
same for all UWP series
transmitters (UTX-B1/H1).
Refer to the pdf files “Sony Wireless
Microphone System Frequency List”
on the supplied CD-ROM for details
on the selectable channel groups and
channels (for the U.S.A. and Europe)
or the supplied leaflet “Sony Wireless
Microphone System Frequency List”
(for Australia).
1
Turn on the transmitter while
pressing down the SET button.
Keep pressing the SET button
until the display section
parameters that were displayed
when the unit was last turned off
start to flash.
2
Press the SET button repeatedly
until the channel number (or
frequency) indication appears.
3
Press the + or – button to select
the channel number (or
frequency).
Pressing the + button cycles the
indication in the order shown in
the tables in the pdf files “Sony
Wireless Microphone System
Frequency List” on the supplied
CD-ROM (for the U.S.A. and
Europe) or the supplied leaflet
“Sony Wireless Microphone
System Frequency List” (for
Australia).