Sony UPW-C1/C2 - Manual (Page 25)

25
A RF (radio frequency) indications
The number of dots indicates the RF
input level.
B AF (audio frequency) indication
Appears whenever the output audio
signal is stronger than the reference
level.
C BATT (battery) indication
Shows the battery condition.
For details, see “Power Supply” on
page 29.
D CH (channel) indication
Shows the reception channel. Each
time you press the SET button, the
channel indication changes as follows.
For details, see “Settings” on page 37.
5 + (+ selection) / – (– selection/
reset) buttons
Press these buttons to set the reception
channel and frequency. The “–”
button resets the accumulated battery
use time to “00:00”. These buttons can
also be used to adjust the monitor
level.
6 Battery compartment
Accommodates two LR6 (size AA)
alkaline batteries.
For details on how to insert the
batteries, see “Power Supply” on
page 29.
7 SET button
Press to change display parameters.
For details, see “Settings” on page
37.
8 POWER switch
Turns the power of the tuner ON or
OFF.
9 OUTPUT (audio output)
connector (3.5-mm diameter stereo
mini jack)
Connect one end of the supplied XLR-
BMP conversion cable here and the
other end to the microphone input on a
camcorder, mixer, or amplifier. If the
microphone input connector on the
device connected to the tuner is a
stereo mini jack, use an optional mini
plug
y stereo mini plug conversion
cable (RK-G139, etc.) and connect the
mini plug to the tuner and stereo mini
plug to the microphone input
connector on the device.
AF
RF
BATT
CH
A B
D
C
The D channel indication for
U66 model is shown.
Reception
channel
Reception
frequency
Accumulated
battery use
time
Press
the
SET
button.
The channel/frequency indications for
U66 model are shown.