Satellite receiver and vcr – Sony KDP-51WS550 User Manual
Page 33
32
SETU
P
SETU
P
S
E
TU
P
SETU
P
Set
up
SETU
P
Satellite Receiver
and VCR
To connect a satellite receiver and VCR
1
Connect the satellite antenna cable to the satellite receiver’s
satellite input jack.
2
Connect the CATV cable to the VCR’s VHF/UHF input jack.
3
Use a coaxial cable to connect the VCR’s VHF/UHF output jack
to the TV’s CABLE jack.
4
Use an A/V cable to connect the satellite receiver’s A/V output
jacks to the VCR’s A/V input jacks.
5
Use an A/V cable to connect the VCR’s A/V output jacks to the
TV’s A/V input jacks.
6
Run the Auto Setup program, as described in “Setting Up the
Channel List” on page 41.
Notes on Using This Connection
Using
S VIDEO jacks?
See page 23.
To Do This ...
Do This ...
Watch the satellite receiver
Press
TV/VIDEO
repeatedly to select the VCR input (VIDEO 1 in the
illustration).
The VCR may need to be turned on and set to the satellite receiver input.
Watch the VCR
Press
TV/VIDEO
repeatedly to select the input to which the VCR is connected
(VIDEO 1 in the illustration).
Set up the TV remote control
to operate the satellite
receiver or VCR
If you have a non-Sony VCR or satellite receiver, you must program the
remote control. See “Programming the Remote Control” on pages 49-50.
Activate the TV remote
control to operate the satellite
receiver or VCR
For the satellite receiver, press
SAT/CABLE FUNCTION
. For the VCR, open the
outside cover, as shown on page 48. Then set the A/V slide switch to the
position you programmed for the VCR.
Control satellite receiver and
VCR functions with the TV
remote control
See “Operating a Satellite Receiver” on page 51 and “Operating a VCR” on
page 51.
Label video inputs to easily
identify equipment connected
to the TV
See the instructions for setting up Video Labels on pages 103-104.
AX1 PJ.book Page 32 Wednesday, April 30, 2003 2:13 PM