beautypg.com

General – Sony KDP-51WS550 User Manual

Page 115

background image

114

O

ther

Inf

o

O

ther

Inf

o

Wel

com

e

O

ther

Inf

o

S

E

TU

P

SETU

P

General

Problem

Possible Remedies

How to reset TV to
factory settings

Turn on the TV. While holding down the

RESET

button on the remote

control, press the

POWER

button on the TV. (The TV will turn itself off, then

back on again.) Release the

RESET

button.

How to restore Video settings
to factory settings

Press the

RESET

button on the remote control while in the Video Menu (see

page 92).

How to restore Audio
settings to factory settings

Press the

RESET

button on the remote control while in the Audio Menu (see

page 94).

Cannot cycle through the
other video equipment
connected to the TV

Be sure the

Video Label

option is not set to

Skip

(see page 104).

Cannot operate Menu

If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.

Lost password

In the password screen (see page 100), enter the following master
password:

4357

. The master password clears your previous password; it

cannot be used to temporarily unblock channels.

LED on front panel is lit

The STAND BY LED (see page 15) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.

The TIMER LED (see page 15) indicates that the timer is set. When the
timer is set, this LED will remain lit even when the TV is turned off.

The i.LINK STANDBY LED blinks when the signal from an i.LINK device
is being shown.

The signal from a selected
i.LINK device is not being
displayed

If you have several i.LINK devices connected and operating at once, the TV
may not be able to display the signal from the selected device. Turn the
other i.LINK devices off, and reselect the desired i.LINK device.

AX1 PJ.book Page 114 Wednesday, April 30, 2003 2:13 PM