Sony Cyber-shot 4-172-679-12(1) - Manual (Page 113)

Ta
ble
of
co
nte
n
ts
Op
e
rat
io
n
S
ear
ch
MENU/Settin
g
s
Se
ar
ch
In
de
x
113 GB
The remaining charge indicator is incorrect.
• This phenomenon occurs when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication.
• Battery capacity decreases over time and through repeated use. If decreased usage time between
charges becomes significant, it is probably time to replace it with a new one.
Cannot charge the battery pack.
• You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery charger
to charge the battery.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again within the
proper charging temperature range (10 °C to 30 °C (50 °F to 86 °F)).
• Refer to page 128 for details.
Cannot record images.
• If images are recorded on the internal memory even when a memory card is inserted into the camera,
make sure that the memory card is fully inserted into the camera.
• Check the free capacity of the internal memory or memory card. If it is full, do one of the following:
– Delete unnecessary images (page 38).
– Change the memory card.
• You cannot record images while charging the flash.
• When recording movies, it is recommended that you use the following memory cards:
– “Memory Stick PRO Duo” (Mark2) media, “Memory Stick PRO-HG Duo” media
– SD memory card, SDHC memory card or SDXC memory card (Class 4 or faster)
• Set [Demo Mode] to [Off] (page 83).
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
• Set [Demo Mode] to [Off] (page 83).
Anti-blur function does not work.
• The anti-blur function may not work properly when shooting night scenes.
• Shoot after pressing the shutter button halfway down.
• If camera shake is excessive, the anti-blur function may not be effective even when [SteadyShot] is
activated.
Recording takes a long time.
• When the shutter speed becomes slower than a certain speed in low light conditions, the NR (Noise
Reduction) slow shutter function is activated automatically to reduce the image noise. Under such
conditions, recording takes a long time.
• The Anti Blink function is working. Reset [Anti Blink] to [Off] (page 61).
Shooting still images/movies