Sony SNC-CS50N - Manual (Page 79)

Ot
her
s
Attaching a CS-mount Lens
79
Attaching a CS-mount
Lens
You can use a CS mount lens other than the supplied lens
with this camera.
Suitable lens
The lens must be a CS-mount type of less than 1 kg (2 lb
4 oz). The protrusion behind the mounting surface must
be 4 mm (3/16 in.) or less.
About the auto-iris lens
You can use a DC-servo type auto iris lens with this
camera.
To connect the auto iris lens, first replace the plug on the
lens cable with a plug that fits the LENS connector (not
supplied).
1
Detach the old plug from the lens cable.
2
Solder the wires of the lens cable to the pins of the
plug.
For cable pin assignment, refer to the instruction
manual of the lens.
Detaching the Lens
1
Disconnect the lens cable from the auto iris lens
connector.
2
Turn the lens counterclockwise to detach it from the
camera.
Attaching the Lens
1
Align the lens with the lens mount of the camera,
and turn it clockwise until it is secured.
2
Insert the plug of the lens cable into the auto iris
lens connector.
When fitting a manual-iris lens, omit step 2.
3
If the focus cannot be adjusted correctly at
∞
(infinite), adjust the focal length by turning the
ADJUST screw with a Phillips-head screwdriver.
1 Cover
2 Lens cable
3 Rib (If the cable is thick, cut this off.)
4 Plug (not supplied)
5 Pin 4: Drive – (Ground)
6 Pin 2: Control +
7 Pin 1: Control –
8 Pin 3: Drive +
CS-mount lens
4 mm (3/16 in.)
or less
1
8
7
6
5 4
3
2
2
1
1
3
2