Sceptre X23PV-KOMODO - Manual (Page 33)

SCEPTRE X23 HDTV User Manual
- 33 -
www.SCEPTRE.com
Connecting a PC
1. Make sure the power of X23 LCD HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your
PC and the other end to the VGA port on the back of your X23 LCD
HDTV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the
other end to the VGA Stereo Input port.
4. Turn on the power of the X23 LCD HDTV and your PC.
5. Use the remote control’s source button or the source button on the right
side of the TV to switch to VGA.
6. Change your PC resolution to 1360x768 at 60hz refresh rate.
7. Press MENU to use the OSD’s SETUP option.
8. Under the SETUP option select PC function.
9. Under PC function use AUTO ADJUST to adjust the screen, AUTO
COLOR to adjust the color and use PREF. RESOLUTION to select
1360x768 at 60hz.
Please Note :
• For the best results, please set your PC resolution to
1360x768 at 60 Hz. Please refer to the PC or graphic card’s
manual for further instructions on how to set your resolution
and refresh rate.
• Please refer to your PC manual for video output requirements
of the video card.
• The VGA port of the TV features a power saving mode which
will automatically turn off the TV, if there’s no signal provided
for more than 5 minutes.