SMC Networks Barricade SMCWBR14-G - Manual (Page 23)

11
C
ONFIGURING
C
LIENT
TCP/IP
To access the Internet through the Wireless Barricade, you must
configure the network settings of the computers on your LAN to
use the same IP subnet as the Wireless Barricade. The default
network settings for the Wireless Barricade are:
Gateway IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note: These settings may be changed to suit your network
requirements, but you must first configure at least one
computer as described in this chapter to access the
Wireless Barricade’s web configuration interface. See
“Configuring the Wireless Barricade g Router” on
page 20 for information on configuring the Wireless
Barricade.
The IP address of the connected client PC should be 192.168.2.x
(where x means 2–254). You can set the IP address for client
PCs either by automatically obtaining an IP address from the
Wireless Barricade’s DHCP service or by manual configuration.