SysKonnect SK-98xx V2.0 - Manual (Page 32)

32 4 Installation of the Driver Software
Installation on Novell NetWare 4.20
To install the network driver on Novell NetWare 4.20, proceed as follows:
1. After you have installed the adapter in your computer, boot NetWare 4.20 (for details,
see chapter 2 "Installation of the Network Adapter").
2. On the console, execute the following command:
load install
.
3. Select D RIVER O PTIONS ( LOAD / UNLOAD DISK AND NETWORK DRIVERS ).
The menu “Driver Options” is displayed.
4. Select C ONFIGURE NETWORK DRIVERS .
The menu “Additional Driver Actions” is displayed.
5. Select D ISCOVER AND LOAD ADDITIONAL DRIVERS .
The system detects the SysKonnect adapter as “PCI Lan Controller 1148.4320....”.
6. To get a list of available drivers, press .
The menu “Select a driver” is displayed.
7. To install an unlisted driver, press (the SysKonnect driver is not listed).
8. To specify the path to the driver, press .
The window “Specify a directory path”
is displayed.
9. Type the path to the driver.
If you are installing from CD-ROM, the menu “Select an action” is displayed. Here, select
C
ONTINUE AND ACCESS THE CD-ROM.
The menu “Select a driver to install” is displayed.
10. Select the driver for your network adapter.
The message “
Do you want to copy driver .LAN?
” is dis-
played.
11. To copy the driver to the server, select Y ES .
If an older version of a SysKonnect driver is installed on the system, the messages “
Save
existing file SYS:SYSTEM\
” and “
Save existing file
SYS:SYSTEM\.LDI?
” are displayed.
12. To continue, select the desired options (Y ES or N O ).
The menu “Board SK-98NW_1 (Driver ) Actions” is displayed.
13. Select S ELECT M ODIFY DRIVER PARAMETERS / PROTOCOLS .
14. Configure the protocols to be used.
15. Configure the parameters, e.g. “slot number”.
16. After the parameters have been configured, select S
AVE PARAMETERS AND LOAD DRIVER .
The driver is loaded.
Once the driver has been installed, the adapter parameters or bindings can be changed
in the autoexec.nfc file using the “Install” tool.
For more information, refer to the corresponding readme file.
Installation on Novell NetWare 5 and 6
The installation procedure for NetWare 5 and 6 is identical.
To install the network driver on Novell NetWare 5 or 6, proceed as follows:
1. After you have installed the adapter in your computer, boot NetWare 5 or 6 (for details,
see chapter 2 "Installation of the Network Adapter").
NetWare detects the new adapter and tries to install a driver.
2. To get a list of available drivers, press .
The menu “Select a driver” is displayed.
3. To install an unlisted driver, press (the SysKonnect driver is not listed).
4. To specify the path to the driver, press .
The window “Specify a directory path” is displayed.