Sony HVR-Z7E - Manual (Page 80)

80
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
• When recording loud sound, the sound may be
distorted at either the input point or the
recording point. If it is distorted at the input
point, adjust the sound using the INPUT TRIM
function. If it is distorted at the recording point,
lower the total volume level manually.
• If you set INPUT TRIM too far to the minus
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
• Test the effect of the INPUT TRIM function
according to the microphone used or the sound
field of the recording site before actual
recording.
B CH1,CH2
Reproduces sound of CH1 and CH2 in
respective channels.
CH1
Reproduces sound of CH1 in channels 1
and 2.
CH2
Reproduces sound of CH2 in channels 1
and 2.
z Tips
• When you select [CH1,CH2] and play back a
tape on your camcorder, sound of CH1 + CH2
comes out of the speakers.
You can monitor the sound dubbed from
another device or recorded through 4-
channel microphone during playback. You
can set how to output the sound.
B CH1,CH2
Outputs only the sound recorded in CH1
and CH2 during recording.
MIX
Outputs mixed sound of the sound
recorded in CH1 and CH2 during
recording and the sound dubbed in CH3
and CH4.
CH3,CH4
Outputs only the sound dubbed in CH3 and
CH4.
AUDIO CH SEL
DV AUDIO MIX
Press the MENU button t select the (AUDIO SET) with the SEL/PUSH EXEC dial.