Standard Horizon Gx5500s - Manual (Page 80)

GX5500S Page 80
KEYPAD
[1(DIM)] key
When in radio mode, this key is used to directly select digit “1” in a
channel number.
Secondary use
Press the [F] key first then press the [1(DIM)] key to access the LCD
Dimmer menu. Refer to section “10.16 LCD DIMMER” for details.
[2(MEM)] Key
When in radio mode, this key is used to directly select digit “2” in a
channel number.
Secondary use
Press the [F] key first then press the [2(MEM)] key, memorize the se-
lected channel into the transceiver scan memory for scanning. When
repeat the same procedures ([F]
Æ [2(MEM)]), will delete the channel
from the scan memory. Refer to section “10.13 SCANNING” for details.
[3(SCAN)] Key
When in radio mode, this key is used to directly select digit “3” in a
channel number.
Secondary use
1) Press the [F] key first then press the [3(SCAN)] key to start and stop
the scanning of programmed channels. Refer to section “10.13 SCAN-
NING” for details.
2) While holding down the [3(SCAN)] key and pressing the [
S] or [T]
key, you can confirm memory channels for scanning.
[4(DW)] Key
When in radio mode, this key is used to directly select digit “4” in a
channel number.
Secondary use
Press the [F] key first then press the [4(DW)] key to scan for voice com-
munications on the priority channel and another selected channel until
a signal is received on either channel (Dual Watch). Refer to section
“10.12 DUAL WATCH (TO CH-16)” for details.
[5(IC)] Key
When in radio mode, this key is used to directly select digit “5” in a
channel number.
Secondary use
Press the [F] key then press the [5(IC)] key to activate intercom function
between RAM+(s) or VH-310 handset(s). Refer to section “10.16 IN-
TERCOM OPERATION” for details.