Standard Horizon Gx5500s - Manual (Page 77)

Page 77 GX5500S
13.5.1 Lat/Lon or Time and SOG Display
Factory default is “Your Vessel’s Current Position,” however, following the steps
below the GPS Information can be changed to “Course Over Ground (COG).”
1. Press and hold down the [CALL(SET)MENU] key until “ RA- RA- RA- RA- RA-
DIO SETUP DIO SETUP DIO SETUP DIO SETUP DIO SETUP” menu appears.
2. Press the [CALL(SET)MENU] key, then select “ NAV DIS- NAV DIS- NAV DIS- NAV DIS- NAV DIS-
PLAY PLAY PLAY PLAY PLAY” with the [ S]/[T] key.
3. Press the [CALL(SET)MENU] key.
4. Press the [
T] or [S] key to select “Pos Pos Pos Pos Pos (Your Vessel’s Cur-
rent Position)” or “ Cru Cru Cru Cru Cru (Course Over Ground).”
5. Press the [CALL(SET)MENU] key to store the data en-
tered, then press the [16/9] key to exit this menu and re-
turn to radio operation mode.