Standard Horizon Gx5500s - Manual (Page 66)

GX5500S Page 66
12.13 TREBLE AND BASS AUDIO TONE CONTROL
Allows the treble and bass of the speaker audio to be adjusted for best listen-
ing in noisy environments. The effect is similar to adjusting the treble and bass
controls on a stereo.
1. Press and hold down the [CALL(MENU)] key
until “ Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup” menu appears.
2. Press the [ENT] key, then select “ Tone Control Tone Control Tone Control Tone Control Tone Control”
in the “ Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup” menu with the CHANNEL
selector knob.
3. Press the [ENT] key, then select “ Bass Bass Bass Bass Bass” with
the CHANNEL selector knob.
4. Press the [ENT] key, then turn the CHANNEL
selector knob to select desired audio response
in the lower frequency range. Available selec-
tions are “–
– – – –6 6 6 6 6” through “+6 +6 +6 +6 +6.”
5. Press the [ENT] key to store the selected set-
ting.
6. Select “ Treble Treble Treble Treble Treble” with the CHANNEL selector
knob, then press the [ENT] key.
7. Turn the CHANNEL selector knob to select de-
sired audio response in the higher frequency range.
Available selections are “–
– – – –6 6 6 6 6” through “+6 +6 +6 +6 +6.”
8. Press the [ENT] key to store the selected setting.
9. To exit this menu and return to radio operation mode press the [16/9] key.
12.14 FOG ALERT TONE FREQUENCY
This selection allows you to select the Tone Frequency for the PA/FOG Opera-
tion. Available selections are “200Hz” through “850Hz” in 50Hz steps. The
default Tone Frequency is 400Hz.
1. Press and hold down the [CALL(MENU)] key until
“ Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup” menu appears.
2. Press the [ENT] key, then select “ FOG Frequency FOG Frequency FOG Frequency FOG Frequency FOG Frequency” in
the “ Radio Setup Radio Setup Radio Setup Radio Setup Radio Setup” menu with the CHANNEL selector
knob.
3. Press the [ENT] key.
4. Turn the CHANNEL selector knob to select desired
tone frequency.
5. Press the [ENT] key to store the selected setting.
6. To exit this menu and return to radio operation mode
press the [16/9] key.