Standard Horizon Gx5500s - Manual (Page 34)

GX5500S Page 34
10.17 INTERCOM OPERATION
Connecting a CMP25 RAM+ or VH-310 Handset to the GX5500S allows inter-
com communications. Refer to section “13.2 INTERCOM OPERATION” for
CMP25 RAM+ Microphone or section “14.2 INTERCOM OPERATION” for VH-
310 Handset.
10.17.1 Communication
1. Press and hold the [5(IC)] key while in the “Radio” mode, the mode is
changed to “Intercom” mode.
2. If your GX5500S is equipped two RAM+ Mic’s (or
VH-310 Handset), select the companion you wish
to communicate (
RAM1 RAM1 RAM1 RAM1 RAM1, RAM2 RAM2 RAM2 RAM2 RAM2, or ALL ALL ALL ALL ALL) with the
CHANNEL selector knob, then press the [ENT] key.
3. When the “Intercom” operation is activated, “ Inter- Inter- Inter- Inter- Inter-
com com com com com” is displayed on the GX5500S, and “IC” is dis-
played on the CMP25 RAM+ or VH-310 Handset.
4. Press the PTT switch. “ Talk Talk Talk Talk Talk” will be
shown on the display.
NOTE: A warning beep will be emit-
ted when the GX5500S microphone’s
PTT switch is pressed while the
RAM+ Mic’s PTT switch is pressed.
5. Speak slowly and clearly into the mi-
crophone, hold the microphone about
1/2 inch away from your mouth.
6. When finished, release the PTT
switch.
7. Press the [CLR] key the mode will revert to “Radio” mode.
(Second Station Mic’s PTT switch is pressed)
(GX5500S’s PTT switch is pressed)
SCAN DW
NAV
WX
CALL SET
ME M IC
U .I .C
M EN U
16
9
ALL
RAM 1
RAM 2
DIST RES S PU LL OPE N
-/ *
J KL
SCA N DW
NAV
WX
CALL S ET
M EM IC
U .I .C
MEN U
16
9
RAM 1 RAM 2 Ù
RAM 1
RAM 2
DIST RES S P ULL OP EN
-/ *
JKL
SCA N DW
N AV
WX
CALL S ET
M EM IC
U .I .C
MEN U
16
9
QUANTUM RAM 2 Ù
RAM 1
RAM 2
DIST RESS P ULL OP E N
-/ *
JKL
SC AN D W
N AV
WX
CALL SET
MEM IC
U .I .C
ME NU
16
9
QUANTUM RAM 1 Ù
RAM 1
RAM 2
DISTRESS P U LL OP E N
-/*
JKL