Sunfire III - Manual (Page 34)

User's Manual
34
CHAPTER 4
INPUTS P2
TUNER
TUNER PRESETS
TAPE
PHONO
8-CHANNEL
8-CH INPUT CONFIGURE
NAME 8-CHANNEL
GAIN TRIM 0 dB
LOCK TO VID VID1
MAIN ZONE ENABLE
TRIGGER RELAY ON
MAIN MENU
TRIMS
MODES
TONE
INPUTS
SETTINGS
Input Menus
These menus let you select which
input you would like to confi gure.
Pressing the joystick right on each
input brings up a second menu which
allows you to confi gure what happens
when each input is selected.
Input Menus
INPUTS
DVD
CD
SAT
VID1
VID2
VCR
Input Confi guration Menus
The example shows the DVD menu.
Name
Use the joystick up/down, and
left/right to change the display
name for any input, up to 9
characters. Move fully to the left
after entering the name.
Gain Trim
Use this to adjust all of your
sources to play at similar levels.
To prevent overloading, the
levels can only be adjusted
downwards. You should try
and trim all the inputs to be the
same average level as your
quietest source.
Default Mode
Set the input to a favorite sur-
round mode or stereo.
Main Zone
Enable/disable the selected
input in the Main Zone. You can
set up your system so any un-
used inputs are not selectable.
From the factory, the inputs
are enabled. If you choose to
disable an input, then it will not
play in the Main Zone.
Full Auto
This turns on/off the fully auto-
matic mode for this input. When
this is on, the TGIII will turn on
and select this input whenever
this input starts to play. You
can deselect any input which
hinders full-auto operation.
Trigger Relay
The Trigger Relay can be set to
turn on whenever the input is
selected. This could be used to
turn on an amplifi er or a video
screen for example.
Zone 2
Enable/disable the input in
Zone 2. You can select the
inputs you wish to play in Zone
2. For example, you might dis-
able the Phono input if nobody
in Zone 2 appreciates your
vintage collection of 78s.
Note: the 8-Channel input menu is
slightly different from the other menus:
It allows you to select a
specifi c video input whenever
the 8-Channel audio input is
selected. Also, this input only
works in the Main Zone, not
Zone 2.
DVD INPUT CONFIGURE
NAME DVD
GAIN TRIM 0 dB
DEFAULT MODE LAST
MAIN ZONE ENABLE
FULL AUTO ON
TRIGGER RELAY ON
ZONE 2 ENABLE