Sunwave Tech. SRC-3310/9320 - Manual (Page 9)

5
• LCD Indicators: LCD stands for Liquid Crystal Display and
these indicators at the top of the display give you
feedback and information. You can look here to see if
the beep is turned on, if the battery has low power, if the
infrared signal was sent OK or if there was an ERROR, and
also to see which page of Touch Screen buttons you are
looking at.
• UART Port: This port allows you to connect the SRC-93
SERIES to a personal computer. See Appendix B -
Accessories on page 44 for more information.
• Backlight / Sleep Key: If pressed quickly, this key will
activate the Touch Screen backlight. If held down for
two seconds you will enter the Sleep menu.
• Page / Date Key: This key allows you to switch between
Page 1 and Page 2 of Touch Screen Buttons. If held
down for two seconds you will see the date and year
then week .
• Learning Eye: This is an infrared sensor used to detect
other remote controls infrared signals. Aim your existing
remote control here when using the SRC-93 SERIES’s
Learning Function.
• Device Keys: These keys allow you to switch between
different devices. Each key may have more than one
device. (For example, the TV key may have TV1 and TV2
for different TVs in your house.) Repeatedly press the
same device key to cycle through all the device names
assigned to that key. The SRC-93 SERIES includes 8
devices as the default with a total of 16 devices
maximum.
• Touch Screen: The touch screen acts as a “virtual”
keyboard on the SRC-93 SERIES. The display is normally
blank when the remote is not in use and can be
activated by simply touching it.
• Function Keys: These keys allow you to enter the SETUP,
DELETE, and MACRO menus. To enter the menu, touch
the function key for two seconds.