Sunwave Tech. SRC-3310/9320 User Manual
Page 23
19
4.
You may also use the TUNING
buttons to increase or decrease
the code.
When finished, press the OK button to
return to the Setup Menu.
When you enter the Manufacture Code , but shows
‘ERROR’ message, two possibilities maybe caused :
1. That code number is not existed among the
Manufacture Code table yet.
2. That code number is not in the range of Manufacture
Code table reserved for the default device screen .
To use automatic search:
Automatic Search
5.
Make sure the SRC-93 SERIES is
pointing at the device you want to
control and press the AUTO button.
The AUTO button will flash while the
SRC-93 SERIES automatically cycles
through the codes. Wait for the
device to turn on and then press the
POWER button or AUTO button to stop
the automatic search.
The last tried code will be displayed
in the upper right hand corner. You
can test this code by pressing
POWER button. (You may need to
press TUNING Down and try the
previous few codes.)
6.
Once your device turns on (or off)
when you press the POWER button,
press the OK button to return to the
SETUP menu.