Sunwave Tech. SRC-3310/9320 - Manual (Page 28)

SRC-93 SERIES User’s Manual
24
Collecting Unrecognized Infrared Codes
Use this procedure if the SRC-93 SERIES is unable to
recognize the infrared signals from another remote
control. (You only see the ERROR indicator when Using
the Learning Function on page 20.)
Once collected you can use the Remote Connector
(see Appendix B - Accessories on page 44 for more info)
to upload the unrecognized codes to your personal
computer and then email them to SUNWAVE for
analysis. SUNWAVE can then update the system
software and send you an updated version that will
recognize the codes.
SUNWAVE service email address is:
[email protected]
All unrecognized codes should be sent to this address.
Every time when you enter the DBUG mode, the SRC-
93 SERIES will replace the previously stored
unrecognized codes by new ones. If you have more
than one remote that is not programmable, please
upload the first remote’s unrecognized codes and then
gather the second remote’s.
To collect unrecognized codes:
Press and hold the SETUP button on
the Touch Screen.
Press each number button (2, 4, 6,
8) until it disappears.
Use the arrow buttons on the
Touch Screen to select DBUG and
then press the OK button.
The rest of the collection procedure is the same as Using
the Learning Function on page 20. When finished press the
EXIT button.