Sharp LC-32DV22U - Manual (Page 54)

52
Removing the stand
Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
• Before performing work make sure to turn off the TV.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
Setting the TV on the wall
CAUTION
• This TV should be mounted on the wall only with the AN-26AG1 (SHARP) bracket for LC-26DV22U/
LC-26DV22U-W or AN37AG2 (SHARP) bracket for LC-32DV22U wall mount bracket. The use of other wall mount
brackets may result in an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using an optional bracket (AN-26AG1 bracket for LC-26DV22U/
LC-26DV22U-W or AN37AG2 bracket for LC-32DV22U) to mount the TV to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
Wall mount bracket. (See the bracket instructions for details.)
Vertical mounting
About setting the TV angle
Unfasten the four screws used to secure the stand in
place.
Detach the stand from the TV.
(Hold the stand so it will not drop from the edge of the
base area.)
NOTE
• To attach the stand, perform the above steps in reverse order.
Angular mounting
1 2
NOTE
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
Angle of TV
Up to 20°
Appendix
hex key
Soft cushion