Sennheiser EK 2000 - Manual (Page 32)

31
Synchronizing a transmitter with the receiver
OR:
̈
Manually set the transmitter to the same frequency bank and channel
that you set on the receiver.
̈
Activate the RF signal on this transmitter.
The transmission link is established.
If you want to set up a multi-channel system:
̈
Repeat the following 4 steps for each additional transmission link:
– Perform a frequency preset scan with the next diversity receiver.
– Select a channel from the same frequency bank as with the first
diversity receiver.
– Synchronize a transmitter with the diversity receiver.
– Activate the RF signal on the transmitter.
Using freely selectable receiving frequencies
You can also freely select the receiving frequencies and store these
frequencies in the frequency banks “
U1 ” to “ U6 ”.
̈
Set each diversity receiver to the same frequency bank (“ U1 ” to “ U6 ”).
̈
On one of the receivers, select a channel within this frequency bank and
assign this channel a receiving frequency (see page 25).
̈
Synchronize a transmitter with this receiver (see the instruction
manual of the transmitter).
OR:
̈
Manually set the transmitter to the same frequency bank and channel
that you set on the receiver.
̈
Repeat for the remaining transmitters and receivers as described
above.
It might be that the freely selected frequencies are not inter-
modulation-free
If you are using frequencies from the frequency banks “ U1 ” to
“ U6 ”, it might be that the receiving frequencies are not intermod-
ulation-free.
̈
Contact your Sennheiser partner who will be pleased to
calculate intermodulation-free frequencies for you (see
www.sennheiser.com).