Sennheiser EK 2000 - Manual (Page 21)

20
Adjusting settings via the operating menu
To transfer these parameters:
̈
Switch the transmitter and the diversity receiver on.
̈
On the receiver, call up the “ Sync ” menu item.
“ Sync ” appears on the display panel of the receiver.
̈
Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface of the
receiver
¹ .
The parameters are transferred to the transmitter. When the transfer
is completed, “
” appears on the display panel of the diversity
receiver. The receiver then switches back to the current standard
display.
To cancel the transfer:
̈
Press the ON/OFF button Ƹ on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was
canceled after 30 seconds,
– you canceled the transfer.
Via the “ Sync Settings ” submenu, you can adjust additional
parameters to be transferred to the transmitters (see page 16
and 28).
¹