Using the diversity receiver, Switching the diversity receiver on/off – Sennheiser EK 2000 User Manual
Page 13
12
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the receiver’s RF level display
“
RF
”
reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the receiver”
on page 30.
Switching the diversity receiver on/off
̈
Push the two battery compartment catches
¸
and open the battery
compartment cover
µ
.
To switch the diversity receiver
on
:
̈
Press the
ON
/
OFF
button
The red
ON
LED
lights up and the standard display “
Frequency/
Name
” appears on the display panel.
To switch the diversity receiver
off
:
̈
Keep the
ON
/
OFF
button
pressed until “
OFF
” appears on the display
panel.
The red
ON
LED
goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 30.
When in the operating menu, pressing the
ON
/
OFF
button
will
cancel your entry (ESC function) and return you to the current
standard display.
¸
¿
µ
¸
Ƹ