JVC YU30052-572 - Manual (Page 14)

14
EN
RECORDING Basic Features (cont.)
START/STOP
VISS
FEATURE: Index Code Marking
PURPOSE: To give you automatic access to any
selected point on a recording. Auto
Marking and Manual Marking are
available.
OPERATION: Auto Marking
An index code is marked to start the
first recording after a cassette is
inserted, as long as the Power switch
is set to “CAMERA”.
Manual Marking
1) Press VISS once to place the index
code. INDEX blinks in the
viewfinder during marking.
NOTE: If VISS is pressed during
Record–Standby mode, the mark is
placed where the Recording Start/
Stop button is pressed.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1) Make sure the camcorder is in the
Record–Standby mode.
2) Press either RETAKE button to
reach the start point for new
recording.
3) Press the Recording Start/Stop
button to start recording.
NOTE: Noise may appear during Retake.
This is normal.
FEATURE: Auto Pause System
PURPOSE: To automatically stop recording
when the camcorder is pointed
down, preventing accidental
recordings of the ground, your feet,
etc.
OPERATION: 1) Set AUTO PAUSE to “ON”. When
the camcorder is tilted down by a
large degree from its horizontal
position during recording, the
Record-Standby mode is
automatically engaged. “AUTO
PAUSE” appears in the viewfinder.
NOTE: ● The Auto Pause System is also
effective when the camcorder is
pointed up, or is positioned upside
down.
● Auto Pause also works when the
camcorder is twisted by a large
degree to the left or right.
● When you want to shoot in any of
the aforementioned positions,
make sure you set AUTO PAUSE
to “OFF”.
AUTO PAUSE
Down
Record-Standby Record
Record-Standby
Record-Standby
Normal Upside down
Up
RETAKE
RM-V706U (provided)