JVC VN-C655U - Manual (Page 21)

21
Attaching the Camera
1.
Attach the drop prevention wire.
As shown in the diagram, take the drop pre-
vention wire from the camera and attach it to
the hook on the Ceiling Mount.
Be sure to connect the drop prevention wire.
Otherwise, the camera will not fit properly to
the Ceiling Mount. If they are engaged forc-
ibly, they may be damaged.
2.
Ensure that the locking screw is loose.
The camera cannot be attached properly if the
locking screw of the Ceiling Mount is too tight
at this stage.
3.
Fit the camera.
Check the position of the camera clamping
bracket and that of the locking screw, and fit
the camera to the Ceiling Mount.
Caution
• Do not connect cameras other than VN-
C655. This may cause the equipment to
malfunction.
• Be sure to attach the safety cable. Other-
wise, the camera could fall to the floor, car-
ing damage to itself and any person pass-
ing underneath.
Attach Drop
Prevention Wire
to this hook.
Drop Prevention
Wire
Camera
Locking screw
Ceiling Mount
Camera clamping
bracket
VN-C655(reed me)_p2-29 04.9.22, 8:18 PM 21