JVC VN-C655U - Manual (Page 13)

13
Set the camera in the following procedure.
Preparation Procedure
❈ In a system where more than one VN-C655 are used, turn on the power for a VN-
C655 first and then setting the camera (
☞
Page 28, Setting the IP Adress for VN-
C655 with V.Networks Setup tool). Only then turn on the power for a second one and
go on to same setting. Repeat the procedure for the other cameras.
(
☞
Page 15)
Step 2 Setting the Network
Install the software [V.Networks Controller], and set the network for the PC
and VN-C655. Also perform the setting with [V.Networks Setup Tool] and reg-
istration of the connected camera with [V.Networks Controller].
Step 4 Operations with V.Networks Controller
With V.Networks Controller, Preset Position can be selected as well as start-
ing and stopping Auto Pan, Auto Trace and Auto Patrol.
Step 3 Setting with V.Networks Controller
Use the installed V.Networks Controller to perform the settings for Auto Pan,
Auto Patrol, Auto Trace, Picture Quality, Preset Position, Alarm and others.
Step 1 Connection and Installation
Firstly, make a hole on the ceiling and connect the power cable, LAN cable,
alarm and others to the terminal of the ceiling-mounting bracket of this unit.
Then, install the camera to a Ceiling Mount Fix a wire securely for preventing
the camera from falling off.
☞
Page 14
☞
Page 23
☞
Page 31
☞
Page 34
VN-C655(reed me)_p2-29 04.9.22, 8:18 PM 13