JBL DVD600II - Manual (Page 22)

22
Remote Control Functions
IMPORTANT NOTE: The remote control for
the JBL Cinema ProPack 600
II may be pro-
grammed to control up to eight devices, includ-
ing the DCR600
II and DVD600 II . It is helpful to
think of the remote as being organized into
“pages,” with one page for each device.
Depending on which device has been selected,
the buttons on that device’s page will perform
different functions, as listed starting on the
next page. These functions may vary from the
labels on the remote, and from one device to
the next. Some buttons may perform no func-
tion at all for a given device.
In order to go to the page for a particular
device, such as the DVD600
II , you will need to
press the Input Selector button for that device
(DVD in this case), located in a grouping just
below the power buttons. The remote will then
function as if it were dedicated to the DVD600
II .
If you would like to make an adjustment that
affects the DCR600
II receiver, such as turning
the volume up or down, you must first go to
the page for the DCR600
II by pressing its Input
Selector button. This button is labeled “Main”
on the remote. The exception to this rule is
that the transport functions of the DVD600
II –
Play, Forward and Reverse Search, Stop,
Pause, and Previous and Next Chapter/Track
Skip – may be accessed from the “Main” page,
without having to jump to the DVD page.
- -
PROGRAM
INDICATOR LED
a Power Off Button: Turns off the power
to a device selected by pressing its Input
Selector.
b Power On Button: Turns on the power
to a device selected by pressing its Input
Selector.
c Mute Button: Press to momentarily
silence the DCR600
II or TV set being con-
trolled, depending on which device has been
selected.
When the remote is being programmed to
operate an external device, such as a CD
player, this button is pressed, together with
the Input Selector button for the new device,
to begin the programming process.
d DVD Input Selector: Pressing this
button will perform three actions: 1) If the
DCR600
II is not turned on, it will power up.
2) It will select DVD as the input source.
3) It will switch to the page for the DVD600
II ,
which will cause the remote to operate only
the DVD changer. Press the Main Button
h
to return the remote to control of the DCR600 II
receiver.