beautypg.com

Dvd600, Front panel controls – JBL DVD600II User Manual

Page 19

background image

19

DVD600

II

Front Panel Controls

Main Power Switch: Press this button

to apply power to the DVD600

II

. When the

switch is pressed in, the unit is placed in a
Standby mode, as indicated by the amber
Power Indicator

surrounding the

System Power Control

. This button

MUST be pressed in to operate the unit. To
turn the unit off and prevent the use of the
remote control, this switch should be pressed
until it pops out from the front panel so that
the word “OFF” may be read at the top of the
switch.

NOTE: This switch is normally left in the “ON”
position.

System Power Control: When the

Main Power Switch

is “ON,” press

this button to turn on the DVD600

II

; press it

again to turn the unit off. Note that the Power
Indicator

in the center of the switch

will turn green when the unit is on.

Power Indicator: This LED will be illu-

minated in amber when the unit is in the
Standby mode to signal that the unit is ready
to be turned on. When the unit is in operation,
the indicator will turn green.

Disc Tray: Holds up to five DVD or CD

discs that can be played one at a time in the
DVD600

II

.

Disc Skip: Press twice in quick succes-

sion to change the disc being played. This will
move the tray forward to the next occupied
position, skipping over the empty-disc
positions.

Search Forward/Reverse: Press to

move forward or backward through a disc at
one of four speeds. Each press and release will
increase the search speed, as indicated in the
on-screen display. Once you have selected the
desired speed, release the button and the disc
will continue to search at fast speed. To
resume normal playback speed, press the
Play Button

.

Open/Close Button: Press to open or

close the Disc Tray

. Upon closing the

disc tray, the On Screen Library system will
begin to identify all loaded discs.

Skip Forward/Reverse: Press to move

forward or backward through the music tracks
or chapters on a disc.

Stop: Press once to place the disc in the

Resume mode, which means that playback will
stop, but (as long as the tray is not opened or
the disc changed) DVD playback will continue
from the same point on the disc when the Play
button is pressed again. Resume will also work
if the unit was turned off. To stop a disc and
have play start from the beginning, press the
button twice.

Play/Pause: Press to begin playback of

a disc, or to momentarily pause playback. If a
DVD is playing, action will freeze and a still
picture will be displayed when the button is
pressed.

Direct Access Buttons: Press one of

these buttons to play any of the five discs
loaded in the Disc Tray.

Information Display: This display con-

tains a variety of indicators that provide infor-
mation about the status of the DVD600

II

and

the disc currently playing.

Display Dim: Press this button to adjust

the brightness of the Information Display by
50% or to turn the display off completely in the
following order: FULL BRIGHTNESS ➔ HALF
BRIGHTNESS ➔ OFF ➔ FULL BRIGHTNESS.

Remote Sensor: The sensor that

receives the infrared commands from the
remote control is behind this area. Do not
cover or obscure this part of the front panel, in
order to avoid a malfunction with the remote.

96KHz 24bit

This manual is related to the following products: