JVC HM-DH30000U - Manual (Page 7)

EN
7
S200
DV IN
i.LINK IN/OUT
DIGITAL OUT OPTICAL PCM/DOLBY DIGITAL
R
Y
L
P B /C B
VIDEO
P R /C R
S VIDEO S VIDEO
AUDIO R
IN(L-1)
IN (L-2)
L(MONO) VIDEO
REMOTE PAUSE/ AV COMPU LINK
CABLE BOX
ANTENNA
AUDIO
OUT OUT
OUT
TV
IN
VHF/UHF
IN
INSTALLING YOUR NEW VCR
Matching
Transformer
(not supplied)
AC Power
Cord
Audio Cable
(supplied)
TV
ANTENNA IN
(Antenna or cable input)
Back of
VCR
AC Outlet
Antenna or Cable
Flat Feeder
Coaxial Cable
Connections
AUDIO OUT
To Audio
Input
Connectors
RF Cable
(supplied)
To 75
Ω
termninal
Basic Connection
1 Check contents
Make sure the package contains all of the
accessories listed in “SPECIFICATIONS”
(
੬ pg. 81).
2 Situate VCR
Place the VCR on a stable, horizontal surface.
3
Connect VCR to TV
The following connections are required.
1
Disconnect the TV antenna from the TV.
2 Connect the TV antenna cable to the
ANTENNA IN terminal on the rear of the VCR.
3 Connect the supplied RF cable between the TV
OUT terminal on the rear of the VCR and the
TV’s antenna input terminal.
4 Connect an audio/video cable between the
AUDIO/VIDEO OUT connectors on the rear of
the VCR and the audio/video input connectors
on the TV.
S-VIDEO Connection
● If you have a TV with S-VIDEO input terminals, see
"S-VIDEO Connection" on page 8.
Component Video Connection
● If you have a TV with component video input
terminals, see "Component Video Connection" on
page 8.
4
Connect VCR to power source
Connect the AC power plug to the AC outlet.
● The clock and tuner channels will
automatically be set when the antenna is
connected and when the AC power cord is first
connected to an AC power outlet (
੬ pg. 9).
(If “Auto” or “CH” is displayed on the front display
panel before the VCR is turned on, the clock and
tuner channels are being set automatically. Wait
until the clock time is displayed on the front display
panel before turning on the VCR.)
5
Final preparation for use
Turn on the VCR.
● You can now perform basic playback
( ੬ pg. 21) or basic recording (੬ pg. 26).
NOTES:
● Your TV must have audio/video input connector for the
connection to the recorder.
● Even if you are using audio/video cables to connect your VCR
to your TV, you must also connect it using the RF cable. This
will ensure that you can record one show while watching
another (
੬ pg. 29).
● For full identification of the VCR’s rear panel, refer to the
Index (
੬ pg. 77).
● When you play back the picture of 1080i, 720p, 480p image
format, the signal is not output from the S-VIDEO or VIDEO
output connector.
TV OUT
Video Cable
(not supplied)
To Video
Input
Connectors
VIDEO OUT