JVC HM-DH30000U - Manual (Page 65)

EN
65
1 2 3
4 5 6
7 8 9
0
VCR TV CABLE/DBS
3
3
2
Load cassettes
Insert the playback cassette into the playback
VCR and the cassette to be recorded on into the
recording VCR.
3 Select input mode on recording VCR
Select the correct external input on the other
VCR.
● On this VCR (when using this VCR as the
recording VCR);
L-1 or L-2 — when connecting the other VCR
to the audio/video input
connectors or the rear panel.
F-1 — when connecting the other VCR
to the audio/video input
connectors on the front panel.
I-1 etc. — when connecting the other VCR
to i.LINK IN/OUT connector.
Press the Number key “0 (AUX)” or CH +/–.
NOTES:
● When using this VCR as the recording VCR, set the
video input terminal setting correctly (
੬ pg. 63).
● When using this VCR as the playback VCR for
editing, set “DIGITAL R3” to “OFF” (
੬ pg. 53).
4 Select edit mode
Set the edit mode to “ON” for the VCRs if such a
mode is equipped.
● On this VCR, set “PICTURE CONTROL” to
“EDIT” (
੬
pg. 53).
5
Start playback
Press PLAY ( 3 ) on the playback VCR.
NOTE:
If the playback VCR is equipped with a superimpose/
OSD disable feature then set it to “OFF” before starting
playback (
੬ pg. 56).
6 Start recording
Press REC (
¶ ) on the recording VCR.
NOTES:
● Be sure to select “AUTO” for “PICTURE CONTROL” (or
“NORM” when “V, CALIBRATION” is set to “OFF”) after you
finish dubbing the tapes (
੬ pg. 53).
● When dubbing using the i.LINK connector, set the recording
speed on the recording VCR to the same speed as the source
tape on the playback VCR.