Basic playback and recording, Basic playback – JVC HM-DH30000U User Manual
Page 21
EN
21
1
BASIC PLAYBACK AND RECORDING
Basic
Playback
This VCR can check the tape condition during playback
(and recording), and realizes the best possible pictures.
● This recorder can play back tapes that have been
recorded in D-VHS (MTP), S-VHS and VHS formats.
● When playing back a tape, this recorder automatically
identifies the recording format (D-VHS, S-VHS, or
VHS).
● When you play back a tape recorded on this VCR, you
can use the Video Navigation function (
੬ pg. 42).
1
Load a cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
● The VCR turns on automatically.
● The counter is automatically reset to “0:00:00”.
● The tape will run for a few seconds while the
VCR searches for the tape number. If the tape
number is found, it will be shown on the TV
screen if “SUPERIMPOSE” is set to “ON.”
(
੬ pg. 56)
● If the cassette’s record safety tab has been
removed, playback begins automatically.
2
Start playback
Press PLAY (
3 ).
● Tape speed is automatically detected.
● If “V, CALIBRATION” is set to “ON” (default
setting:
੬ pg. 53), “V, CALIBRATION” appears
on the screen, and this VCR checks the tape
condition during automatic tracking (only
cassettes recorded in the S-VHS or VHS mode).
To stop playback
Press STOP (
7 ) on the Remote or STOP/EJECT ( 7
/
0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW (
1 ).
To fast-forward (when it is not running)
Press FF (
¡ ).
To eject the tape
Press STOP/EJECT (
7
/
0 ) on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press POWER.
NOTES:
●
When you use the Video Navigation function, operate the
VCR only after the tape number is detected; otherwise, you
cannot use the Video Navigation function.
●
When playing back a tape recorded in D-VHS format, the
JOG dial and SHUTTLE ring do not work.
Turn on the VCR and the TV, and select the AV
mode on the TV.
1
2
3
4
5
6
7
8
9
0
VCR TV CABLE/DBS
2
STOP (
7 )
FF (
¡ )
REW (
1 )
POWER
2
STOP/EJECT (
7
/
0 )
POWER
SHUTTLE
ring