JVC HM-DSR100U - Manual (Page 88)

Page 4-42
User and
Installation Guide
4. Press the Up or Down arrow button to set the remote to
the next code. The Down arrow button scans backward,
and the Up arrow button scans forward.
When the correct code is reached, the equipment
(whether VCR, TV, or other) powers OFF.
5. Press the Address button to store the code in the remote.
If the code is valid for your remote, the mode light blinks
three times.
6. Power the equipment back ON.
7. Try some other functions to make sure you have the
correct code. Occasionally the Power function may
work when others do not.
8. If the other buttons work, do the procedure in the
following section.
9. If the other buttons do not work, power the equipment
back on and repeat steps 2 through 7. The scan resumes
from the last code stored.
The mode light flashes rapidly when the scan has
returned to the starting point and all codes have been
tested for that equipment.
Note: Remember that the remote may not control some
equipment models.
ADDRESS