JVC HM-DSR100U - Manual (Page 28)

Page 3-2
User and
Installation Guide
C
HANGING
M
ODES ON THE
R
EMOTE
Use the Mode button to set the remote to control other electronic components, such as your
TV. See Mode Button on page 2-9 for more information. To change modes, do the following:
Press the Mode button on the remote
repeatedly until the appropriate mode
light flashes rapidly.
For example, to control the built-in
satellite receiver, make sure the SAT
light is flashing. Or for the D-VHS
mode, which is used to control the
built-in video recorder and local timer,
the D-VHS light should be flashing.
S
ETTING THE
R
EMOTE
A
DDRESS
If your recorder turns ON or OFF, or does anything else without you pressing any buttons, it
may be responding to signals from another nearby remote control. To prevent undesired
operation of your recorder by a neighbor’s remote, you can address your remote to the
recorder. You may choose from 15 different addresses.
Note: If your remote is addressed to the recorder, you may need to reprogram this address
when you change the batteries in the remote.
MODE
TV/VCR
POWER
SAT TV D-VHS AUX
Remote Buttons
1. Make sure that fresh batteries are installed in
the remote.
2. Press the Mode button until the remote is in SAT
mode. The SAT mode light flashes rapidly to
indicate the mode.
3. Press the Address button once. The SAT mode
light continues to flash, but at a slower rate.
4. Enter a number from 1 to 15 using the number pad
buttons. The SAT mode light stops flashing and
stays lit.
Note: Do not put a zero before the number
when entering this number.
MODE
ADDRESS
1 2 3
4 5 6
7 8
0
9