JVC CA-D752TR - Manual (Page 43)

39
English
CAUTION: If the Unit is unplugged, or a power failure occurs, the timer
setting will be erased in a few days. If the settings are erased in this
way, reset the timer settings.
Setting the Recording Timer
With the Recording Timer you can make a tape of a radio broadcast automatically whether or not you are
home. For the timer to work correctly, you need to make sure of the following in addition to setting the
time for the Tuner and Cassette Deck to come on:
You can set the Recording Timer whether the Unit is on or off.
The tape you want to record onto must be in Deck B.
Procedure for Setting the Recording Timer
1. Press TIMER/CLOCK repeatedly until “REC” appears on the display.
The REC indicator flashes on the display.
• Each time you press the button, the timer setting indication changes as follows:
DAILY = ON TIME (flashes) = REC = ON TIME (flashes) = Clock setting = Cancelled
(current source) = (back to the beginning)
Note: If the clock has not been set, even if TIMER/CLOCK is pressed you cannot select the Recording
Timer.
2. Press TIMER/CLOCK again.
After “ON TIME” flashes for 2 seconds, it switches to the time setting display.
3. Set the time you want the Unit to be turned on.
Press
4 P. DOWN or ¢ P. UP on the MULTI CONTROL to adjust the hours and press SET. Then
press 4 P. DOWN or ¢ P. UP to adjust the minutes and press SET .
4. Set the time you want the Unit to be turned off.
Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to adjust the hours and press SET. Then
press 4 P. DOWN or ¢ P. UP to adjust the minutes and press SET.
5. Select the Recording band.
Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select “TUNER FM” or “TUNER
AM” and press SET.
6. Select the preset channel for the station to be recorded.
Press
4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select.
7. Press SET.
The REC indicator stops flashing and remains lit. The on-time, off-time, and Recording band
(“TUNER FM” or “TUNER AM”) appear on the display.
Turn the power off if you made the timer settings with the power turned on.
A few seconds before the on-time for the recording, the Unit automatically turns on the power. When
the on-time comes, recording starts using the selected source. A few seconds before the off-time,
“OFF” flashes on the display. When the off-time comes, the power is automatically turned off.
Before the timer starts
Check that tape direction is correct. This is important especially when Reverse Mode is off.
Set Reverse Mode on if you want to record on both sides of the tape.
The volume level is automatically set to 0 when Recording Timer starts.
It is very easy, and can be very disappointing, to forget to put in a
tape, or to accidentally leave a tape in Deck B you don’t want
recorded over. Although this happens to almost everyone at one time
or another, we hope it won’t happen to you!
To change the Recording Timer setting
Repeat the setting procedure from the beginning.
EN.CA-D752TR[E]/F 23/4/98, 2:41 pm 39