JVC CA-D752TR - Manual (Page 29)

25
English
On the Remote Control
Press CD CONTROL then press 3.
The source is set to CD and play starts from the first track of the currently selected CD whose disc
number shown on the CD indicator.
•
If the above operation is carried out while the power is on standby, the power is automatically
turned on.
Press DISC (1 to 3) of the disc you want to play.
The source is set to CD and play starts from the first track of the selected CD.
COMPU PLAY
When DISC (1 to 3) on the Remote Control is pressed while the power is on standby, the power is
automatically turned on.
To stop playing the disc, press
7 STOP (or 7 on the Remote Control). The display will show the total
number of tracks and total playing time of the disc that was playing followed by the playing time of the
first track.
To stop play and remove the disc, press 0 for the disc being played.
To pause, press CD £/8 (or 8 on the Remote Control). The playing time will flash.
To cancel pause, press CD
£/8 (or 3 on the Remote Control). Play continues from the point where it
was paused.
Selecting a Track —————————————————————
Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select the
track.
The selected track starts playing.
Each time you press 4 P. DOWN or ¢ P. UP, the track changes by one.
Press and hold 4 P. DOWN or ¢ P. UP to continuously change tracks.
Locating a Track with the Remote Control Directly ———
Using the number keys on the Remote Control allows you to go directly to the beginning of any track.
1. Press the DISC (1 to 3) for the disc tray containing the track you
want to listen to.
• Example: for the third disc, press DISC 3.
2. Enter the number of the track you want to listen to with the
number keys.
The selected track starts playing.
•
Example: for track 5, press 5. For track 15, press +10 then 5. For track 20, press +10, then 10. For
track 32, press +10 three times, then 2.
Fast Forward / Reverse ——————————————————
Use TUNING DOWN 1 or ¡ TUNING UP on the MULTI CONTROL.
For Fast Forward, press and hold down ¡ TUNING UP. For Reverse, press and hold down
TUNING DOWN
1. Release the button when the part you wish to listen to is reached.
Changing Discs While Playing ———————————————
You can replace a CD in a tray not being used, while another CD is playing.
1. Press 0 of the tray not being used.
The tray opens.
2. Replace the disc in the tray.
3. Press 0 to close the tray.
or
or
CD CONTROL \
DISC 1 DISC 2 DISC 3
or
or
DISC 1 DISC 2 DISC 3
PTY/EON
TEST TONE
CENTER MODE
DELAY TIME
L BALANCE R
CENTER
LEVEL
3CH LOGIC PRO LOGIC
DISPLAY MODE
– SELECT +
– +
REAR
LEVEL – +
EN.CA-D752TR[E]/F 23/4/98, 2:41 pm 25