JVC CA-D752TR - Manual (Page 28)

24
English
Loading CDs
1. Press 0 on the CD Player you want to insert the disc onto.
“OPEN” appears on the display and the disc tray slides out.
COMPU PLAY
When
0 is pressed while the power is on standby, the power is automatically turned on.
2. Place a CD, with its label side up, onto the tray.
ATTENTION: To avoid malfunctions
when you play a CD, set the CD in
the right place at the center of the tray.
3. Press 0 to close the tray.
“CLOSE” appears on the display.
4. Repeat steps 1 to 3 to insert other discs onto the other trays.
• To continue putting discs onto other trays, even if a tray is open, by pressing the
0 button of
another disc tray, the open tray will close automatically, and the new disc tray will slide out.
When you place a CD onto the currently selected tray, whose disc number shown on the CD indicator,
reading of the CD starts. The total number of tracks and total playing time appear after the reading is
completed, then the playing time of the first track appears.
To put an 8 cm CD onto a tray, insert it so that it is aligned with the groove in the tray’s center.
If a tray is open when the System switches to the standby mode, the tray will close automatically.
Basics of Using the CD Player —
Continuous Play
Playing a CD ————————————————————————
Prepare the CDs.
On the Unit
Press CD £/8.
The source is set to CD and play starts from the first track of the currently selected CD whose disc
number shown on the CD indicator.
Press DISC (1 to 3) of the disc you want to play.
The source is set to CD and play starts from the first track of the selected CD.
COMPU PLAY
When CD £/8 or DISC (1 to 3) is pressed while the power is on standby, the power is automatically turned on.
When you press CD
£/8 or DISC (1 to 3) while the disc tray is open, the tray will automatically
close before beginning to play.
If there is no CD in the disc tray, “NO DISC” appears on the display.
Playing order of discs
When playback starts from DISC 1, the playing order is DISC 1 = DISC 2 = DISC 3.
When DISC 3 has finished, the CD Player stops.
When playback starts from DISC 2, the playing order is DISC 2
= DISC 3 = DISC 1.
When DISC 1 has finished, the CD Player stops.
When playback starts from DISC 3, the playing order is DISC 3
= DISC 1 = DISC 2.
When DISC 2 has finished, the CD Player stops.
•
If any of the disc trays are empty, the CD Player skips that disc tray and continues through the
remaining disc trays in the order shown above. When the last disc has finished playing, the Unit
will stop automatically.
CD
CORRECT INCORRECT
Tray
\ \
Reading now (flashing) Total number of tracks
and playing time
Playing time of the 1st
track
EN.CA-D752TR[E]/F 23/4/98, 2:41 pm 24