Getting ready to use dolby 3 channel logic, Using dolby surround, 17 english – JVC CA-D752TR User Manual
Page 21
17
English
Getting Ready To Use Dolby 3 Channel
Logic
Speaker Arrangements for Dolby 3 Channel Logic ————
Setting-up Dolby 3ch Logic ————————————————
1. Press PRO LOGIC/3CH LOGIC to select 3CH LOGIC.
Each time you press the button, Dolby Surround programmes change as follows:
=
PRO LOGIC
=
3CH LOGIC
=
OFF
= (back to the beginning)
When using the Remote Control, press SHIFT then press the 2 3CH LOGIC.
•
Perform the steps below using the buttons on the Remote Control.
2. Select the desired Centre Speaker mode.
Press SHIFT on the Remote Control then press 6 CENTER MODE.
Each time you press the button, Centre Speaker modes change as follows:
=
NORMAL
=
WIDE
=
OFF
=
(back to the beginning)
3. Set the volume to the level you like.
4. Press 3 TEST TONE.
A test tone comes out of the speakers in the following order:
•
When “OFF” is selected for Centre Speaker mode, no test tone comes out of the centre speaker.
=
LEFT
=
CENTER
=
RIGHT
=
(back to the beginning)
5. Adjust the level for the centre speaker.
Press CENTER LEVEL 5 + or 4 –. Set the level so that it is about
the same as the level from the front speakers.
•
You cannot adjust the level for the center speaker if “OFF” is selected for Center Speaker mode.
6. Press 3 TEST TONE again.
Test Tone mode is cancelled.
This completes the preparations required for using Dolby 3 Channel Logic.
•
You cannot adjust the Delay Time or rear speaker levels in Dolby 3 Channel Logic mode.
Using Dolby Surround
1. Press PRO LOGIC/3CH LOGIC and select the desired mode.
If you are using the Remote Control, press 1 PRO LOGIC or 2 3CH LOGIC after pressing SHIFT.
Make sure that the center speaker and rear speakers have been set up correctly, as described on pages
15 to 17.
2. Playback as source with the
mark.
Enjoy the great sound achieved through Dolby Surround.
To Cancel Dolby Surround Effects
Press PRO LOGIC/3CH LOGIC until the Dolby Surround indicator goes out. If you are using the Remote
Control, press the Dolby Surround buttons (1 PRO LOGIC or 2 3CH LOGIC) after pressing SHIFT.
TV
Front
Speaker
Front
Speaker
Centre Speaker
SHIFT
\
3CH LOGIC
or
CENTER MODE
TEST TONE
CENTER
LEVEL
–
+
TEST TONE
SHIFT
\
3CH LOGIC
or
PRO LOGIC
\
EN.CA-D752TR[E]/F
23/4/98, 2:41 pm
17