JVC HM-HDS4EK - Manual (Page 81)

Masterpage:Right-Full-NoTitle0
81
Filename [HM-HDS4EK_07Sub.fm]
Page 81 April 22, 2003 10:12 pm
VCR SET UP 2
* The default setting is bold in the table below.
8
AUTO SP
]
LP TIMER
ON
OFF
When this function is set to “ON”, the recorder automatically switches to LP mode to allow complete
recording if there is not enough tape to record the entire programme while timer-recording in SP
mode.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-minute tape
Make sure you set this function to “ON”, before the timer-recording starts.
NOTES:
● If you have programmed the recorder to timer-record 2 or more programmes, the second programme
and those thereafter may not fit on the tape if you set “AUTO SP ] LP TIMER” to “ON”. In this case,
make sure the mode is not engaged, then set the tape speed manually during timer programming.
● In order to ensure that the recording fits on the tape, this feature may leave a slight non-recorded
section at the end of the tape.
● There may be some noise and sound disturbance at the point on the tape where the recorder
switches from SP to LP mode.
● The Auto SP
] LP Timer feature is not available during ITR (Instant Timer Recording), and the feature
will not work properly with any tapes longer than E-180, or with some tapes of shorter lengths.
● If you perform timer recording with both PDC and the Auto SP
] LP Timer activated, and the
programme goes beyond its originally scheduled length, there may be times when the programme
cannot be recorded in its entirety.
8
B.E.S.T.
ON
OFF
You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to “ON” or “OFF”
(
੬
pg. 45).
8
PICTURE CONTROL
AUTO
EDIT
SOFT
SHARP
This feature helps you to adjust the playback picture quality according to your preference. Normally
select “AUTO”.
AUTO : Provides the optimised picture benefits of the B.E.S.T. Picture System.
EDIT : Minimizes picture degradation during editing (recording and playback).
SOFT : Reduces image coarseness when viewing overplayed tapes containing a lot of
noise.
SHARP : Clearer, sharper-edged picture when viewing images with lots of flat,
same-coloured surfaces such as cartoons.
NOTES:
● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you select
another mode.
● When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish dubbing the tapes.
● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO” to “NORM”.
8
VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical vibration in the picture when
playing back unstable recordings made on another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to “OFF”.
● Regardless of the setting, this function has no effect during recording and during special effects
playback.
● The on-screen display may jitter vertically when this function is set to “ON”.
● To watch recordings with close-caption, set this function to “OFF”.
Total 210 minutes
Approximately 150 minutes Approximately 60 minutes
SP mode LP mode
HM-HDS4EK.book Page 81 Tuesday, April 22, 2003 10:14 PM