JVC HM-HDS4EK - Manual (Page 79)

Masterpage:Right-Full-NoTitle0
79
Filename [HM-HDS4EK_07Sub.fm]
Page 79 April 22, 2003 10:12 pm
HDD SET UP 1
* The default setting is bold in the table below.
HDD SET UP 2
* The default setting is bold in the table below.
VCR SET UP 1
* The default setting is bold in the table below.
8
LIVE MEMORY
OFF
30MIN
1HR
3HR
When this function is set to “30MIN”, “1HR” or “3HR”, hard disk drive illumination lights blue and
you can apply the selected time length to the “Live Memory Features” (
੬
pg. 28).
8
AUDIO REC
NICAM
MONO
When this function is set to “NICAM”, the NICAM audio programmes will be recorded.
When this function is set to “MONO”, the Standard (monaural) audio programmes will be
recorded.
NOTE:
This function works only on NICAM bilingual programme.
8
JUMP TIME
15 MIN
30 MIN
1 HR
You can locate a scene ahead or behind of the currently viewed one by jumping a selected time
interval during playback (or Live Memory Playback) or recording (or Live Memory Recording).
8
DV AUDIO REC
12BIT
16BIT
Select the appropriate mode before recording to the HDD deck.
12BIT : Enables Audio Dubbing later.
16BIT : Audio Dubbing later is impossible but recorded sound quality is higher than
“12BIT”.
NOTES:
● When input mode is set to “D-1”, you cannot change “DV AUDIO REC” setting.
8
AUDIO MODE
SOUND1
SOUND2
MIX
Select the appropriate mode when playing back an audio-dubbed programme on the HDD deck.
SOUND1 : Original recorded sound
SOUND2 : Audio-dubbed sound
MIX : Original recorded sound and Audio-dubbed sound
NOTES:
● When “AUDIO MODE” is set to “MIX”, both the main and sub audio tracks will be audible on
bilingual tapes.
● To select only the main audio or only the sub audio track on bilingual tapes, set “AUDIO MODE” to
“SOUND1”.
8
NAVIGATION
ON
OFF
When a programme is recorded on the cassette with this function set to “ON”, you can use VCR
Navigation (
੬
pg. 36, 55).
HM-HDS4EK.book Page 79 Tuesday, April 22, 2003 10:14 PM