JVC HM-HDS4EK - Manual (Page 52)

Filename [HM-HDS4EK_05Timer.fm]
Masterpage:Left
52
Page 52 April 22, 2003 10:12 pm
REMOTE CONTROL FUNCTIONS
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC video
recorders independently. Each of recorders can respond to one
of four codes (A, B, C or D). The remote control is preset to send
A code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B, C or D code signals.
On the remote control
● Slide TV/CABLE/SAT to the right, then press and hold S-VHS
during steps A through B.
A
Change the remote control code.
Press the number key “1” for A, “2” for B, “3” for C or “4”
for D.
B
Set the remote control code.
Press OK to set the code.
On the recorder
C
Display the code.
Press
4
on the recorder for over 5 seconds while the
recorder is turned off. The code currently set appears on
the front display panel.
● If the code displayed on the front display panel is different
from the code set on the remote control, go to step D.
D
Change the recorder’s code.
Press
8
on the remote control. The code currently set on
the remote control will be applied to the recorder.
?
HM-HDS4EK.book Page 52 Tuesday, April 22, 2003 10:14 PM