JVC GR-DVX48A - Manual (Page 68)

68
EN
PAUSE
START/STOP
INSERT
PLAY
REW
6w
STOP
12 : 34
USING THE REMOTE CONTROL UNIT (cont.)
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in and outpoints. The
original audio remains unchanged.
NOTES:
● Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen
(
੬␣ pg.␣ 41,␣ 43).
● Insert Editing is not possible on a tape recorded in the
LP mode or on a blank portion of a tape.
● To perform Insert Editing while watching in the
television, make connections ( ੬ pg. 22).
1 Play back the tape, locate the Edit-Out point and
press PAUSE (6). Confirm the time code at this
point (
੬ pg. 41, 43).
2 Press REW (2) until the Edit-In point is located,
then press PAUSE (6).
3 Press and hold INSERT (w) on the remote control,
then press PAUSE (6). “6w” and the Time Code
(min.:sec.) appear and the camcorder enters Insert-
Pause mode.
4 Press START/STOP to begin editing.
•Confirm the insert at the time code you checked
in step 1.
•To pause editing, press START/STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP, then
STOP (5).
NOTES:
● Program AE with special effects (੬ pg. 46, 47) can be
used to spice up the scenes being edited during Insert
Editing.
● During Insert Editing, the date and time information
changes.
● If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make
sure you only edit recorded areas.
● During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert
Edting stops (
੬ pg. 91).
Display
Remote sensor