JVC HR-XVC37U - Manual (Page 75)

Masterpage:Right-No-Heading
EN
75
Filename [XVC37U_10Subsidiary.fm]
Page 75 16 June 2004 5:54 pm
* The default setting is bold in the table below.
8 PICTURE CONTROL
NORM
EDIT
SOFT
SHARP
This feature helps you to adjust the playback picture quality according to your
preference. Normally select “NORM”.
NORM : Picture quality is adjusted automatically.
EDIT : Minimizes picture degradation during editing (recording and
playback).
SOFT : Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.
SHARP Clearer, sharper-edged picture when viewing images with lots of flat,
same-colored surfaces such as cartoons.
NOTES:
● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you
select another mode.
● When you select “EDIT” to dub tapes, be sure to select “NORM” after you finish dubbing
the tapes.
8 3DNR
ON
ON (PLAY)
OFF
The 3DNR picture system applies the noise reduction to reduce small noise,
enabling clear picture with less roughness.
ON : The 3DNR picture system is activated to reduce noise appearing on
playback picture of a VHS cassette, on-air picture of the tuner, and
picture from the external source connected to the unit (through the
AUDIO/VIDEO input (F-1) connector). However, this feature does
not affect recording signals. This mode is preferable when small noise
and roughness are obvious on on-air picture of the channel to be
recorded.
ON (PLAY) : The 3DNR picture system is activated only for playback picture of
a VHS cassette. On-air picture of the channel to be recorded and
picture from the external source connected to the unit (through the
AUDIO/VIDEO input (F-1) connector) will not be affected.
OFF : The 3DNR picture system is not activated for playback picture of a
VHS cassette.
NOTES:
● Signals to be recorded onto a tape are not affected even when “3DNR” is set to “ON” or
“ON (PLAY)”.
● Normally it is recommended to keep “3DNR” set to “ON (PLAY)”.
● Depending on the type of tape being used, picture quality may be better with “3DNR” set
to “OFF”.
● If you use the VCR as the source player for editing, be sure to set “3DNR” to “OFF” before
starting.
8 SUPERIMPOSE
ON
OFF
When this function is set to “ON”, various operational indicators appear on the TV
screen. Messages appear in the selected language. (
੬
pg. 20)
NOTES:
● When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to
“OFF” before starting.
● During playback, the operation mode indicators may be disturbed depending on the type of
tape being used.
XVC37U_01.book Page 75 Thursday, June 17, 2004 9:43 AM