JVC HR-XVC37U - Manual (Page 73)

Masterpage:Right-No-Heading
EN
73
Filename [XVC37U_09Editing.fm]
Page 73 18 May 2004 2:16 pm
Connecting To A Dolby Digital Decoder
or An Amplifier With Built-in DTS
(DVD deck only)
These instructions enable you to connect your unit to a Dolby Digital Decoder or an amplifier with built-in DTS.
Make connections.
Connect the unit and a Dolby Digital Decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
● For Dolby digital sound, set “DIGITAL AUDIO OUTPUT” to
“DOLBY DIGITAL/PCM”. (
੬
pg. 79)
● For DTS sound, set “DIGITAL AUDIO OUTPUT” to “STREAM/
PCM”. (
੬
pg. 79)
CAUTIONS:
● This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
1
Back of unit
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO
input
Note for connection:
Remove the protection cap from
the optical cable.
Optical cable (not supplied)
Coaxial cable (not supplied)
DIGITAL AUDIO OUT
(COAXIAL) DIGITAL AUDIO OUT
(OPTICAL)
XVC37U_09Editing.fm Page 73 Tuesday, May 18, 2004 2:16 PM