JVC HR-XVC37U - Manual (Page 71)

Masterpage:Right
EN
71
Filename [XVC37U_09Editing.fm]
Page 71 16 June 2004 5:54 pm
EDITING (DVD DECK)
Digital Audio
Dubbing You can dub selected audio from the unit to a digital audio
device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
A
Make connections.
Connect the unit and a digital audio device using either
an optional optical cable or an optional coaxial cable.
B
Prepare the unit for dubbing.
A Load a disc or a cassette.
B Press DVD or VCR and select the audio to be dubbed.
C Search for the point where you want to start dubbing
by pressing PLAY (4), FF (5) or REW (3) then
press STOP (8).
D Press REW (3) a little, then press PLAY (4) to start
playback.
E Press PAUSE (9) to pause playback a little before the
start point.
C
Prepare the digital audio device for dubbing.
A Insert an MD.
B Select the input mode.
D
Start dubbing.
A Press PLAY (4) to start playback on the unit.
B Start recording on the audio device.
E
End dubbing.
Stop recording on the audio device. Then press STOP (8)
to stop playback on the unit.
NOTES:
● There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
● You can also dub a Video CD or SVCD. Set “DIGITAL AUDIO
OUTPUT” to “PCM ONLY”. (
੬
pg. 79)
● Do not switch between the DVD deck and the VCR deck
during dubbing.
● Turn on the TV and select the VCR channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
1
Rear of unit
Digital audio device
(MD deck etc.)
Coaxial cable
(not supplied)
Player
Recorder
Note for connection:
Remove the protection cap
from the optical cable.
Optical cable
(not supplied)
DIGITAL AUDIO OUT
(OPTICAL)
DIGITAL AUDIO OUT
(COAXIAL)
XVC37U_01.book Page 71 Thursday, June 17, 2004 9:41 AM