JVC COMPACT VHS CAMCORDER GR-AXM30 - Manual (Page 34)

34
EN
A B C
EDITING (cont.)
PREPARE CAMCORDER
2
Insert a recorded tape and set the Power switch to
“PLAY”.
PREPARE VCR
3
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR’s instructions).
SELECT SCENES
ACCESS R.A. EDIT COUNTER DISPLAY
1
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under “IN” on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
“OUT” on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
4 Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
● The RM-V704U/V700U can be used to operate other
camcorder functions as well. Point the
RM-V704U/V700U at the camcorder’s remote sensor
and press any of the following buttons (function apears
in parentheses):
— ON/OFF (camcorder R.A. EDIT)
— IN/OUT (camcorder IN/OUT)
— CANCEL (camcorder CANCEL)
● There must be at least one second between an in-point
and its corresponding out-point.
● To ensure correct operation, leave at least 15 seconds
open between scenes.
● Blank portions of tape cannot be registered as in-points
or out-points.
● If it takes more than 5 minutes to search for an in-point,
the VCR’s Record-Pause mode is cancelled and editing
doesn’t take place.
● Pressing R.A.EDIT clears all in- and out-points from
memory.
● Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
If your TV/VCR
has the SCART
connector, use
the provided
cable adapter.
Open the cover
To AUDIO
and VIDEO
out connectors
REW/FF STOP
R.A. EDIT
IN/OUT
PLAY/PAUSE
To J terminal
(JLIP)
To AUDIO and
VIDEO IN
connectors
To Remote
PAUSE
To Pause-In
VCR (Recording deck)
IN/OUT
ON/OFF
CANCEL
VCR REC STBY
IN OUT
ᮣ 1 0:00:25
2
3
4
5
6
7
8
COUNTER 0:00:25
TOTAL 0:00:00
IN OUT
1 0:00:25 0:01:05
2 0:03:18 0:03:31
3 0:02:33 0:02:53
ᮣ 4 0:04:11
5
6
7
8
COUNTER 0:04:11
TOTAL 0:01:13
RM-V704U or
RM-V700U
(provided)
Editing cable
(provided, 3.5ø
mini-plug cable) Audio and
Video cable
(provided)
CANCEL