JVC COMPACT VHS CAMCORDER GR-AXM30 - Manual (Page 11)

EN
11
25MIN
60MIN
59MIN
3MIN
2MIN (Blinking)
1MIN (Blinking)
0MIN (Blinking)
*- - -MIN
(Now calculating)
STOP RECORDING
4
Press the Recording Start/Stop button again to stop
recording.
•The camcorder re-enters the Record-Standby
mode.
NOTES:
● When the power switch is set to CAMERA and the LCD
monitor is opened at an angle of 45 degrees or more,
the LCD monitor switches on and the viewfinder
switches off automatically to save power.
● A cassette holder can’t be opened unless a power
supply is attached.
● There may be a delay after you press EJECT until the
holder opens. Do not use force.
● The tape’s remaining time is displayed in the LCD
monitor or the viewfinder as shown.
● The indicated remaining time is approximate.
● The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
● The tape remaining time indicator is correct only if the
correct tape length has been selected (
੬
pg. 8).
● “TAPE END” appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. “TAPE END” also appears
when a cassette whose tape is already at its end is
loaded.
● While shooting, pressing DISPLAY lets you remove
some indications from the screen (
੬
pg. 44).
● If the Record-Standby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorder’s power shuts off automatically. Set the
Power switch to “POWER OFF”, and then back to
“CAMERA” to turn the camcorder on again.
● If the Recording Start/Stop button is pressed after the
Record-Standby mode has continued for over 5
minutes, recording may not start immediately.
● If you’re recording on a cassette from the middle, use
the RETAKE function (
੬
pg. 14) to find the end of the
last recording so you don’t erase any of it.
● The LENS COVER warning blinks for about 10 seconds
when the camcorder is turned on when the cover is
closed.
● While shooting, sound is not heard from the speaker.
Tape remaining time indicator
DISPLAY button
Start/Stop button
Tally lamp