JVC TK-C553 - Manual (Page 6)

6
Features
Ⅲ Color Dome Camera with integrated
variable-focal-length lens and camera.
Ⅲ Backlight compensation function
provided. Enables improvement of video
image shot with backlit conditions.
Ⅲ Employment of TTL automatic tracking
white balance allows use under various
light source conditions.
Ⅲ One-push auto white balance (AWC)
function.
Ⅲ Control possible via external control
signal conforming to the EIA/TIA RS-
422A or RS-485 standard. The unit can
be controlled using the JVC Remote
Control Unit RM-P2580.
Ⅲ Setup menus can be set using buttons
on the camera body or by external control
signal.
Ⅲ Auto panning and tilting, auto scrolling
and auto patrol possible.
Ⅲ Up to 6 position settings per camera.
Ⅲ Setting of camera text and position text
possible.
Ⅲ Digital zoom enables up to 2× zoom.
Ⅲ Before starting an important recording,
be sure to perform a test recording in
order to confirm that a normal recording
is possible.
Ⅲ We do not accept liability for the loss of
a recording in the case of it becoming
impossible to record due to a problem
in the video camera, VCR or video tape.
Ⅲ We do not accept liability for any
damage to the camera in cases when
it is dropped because of incomplete
installation due to not observing the
installation instructions correctly.
Please be careful when installing the
camera.
Operating Precautions
● To save energy, when it is not being used
turn the system’s power off.
● This camera has been designed for indoor
use. It cannot be used outdoors.
● This camera has been designed
exclusively to be hung from the ceiling.It
may malfunction if it is placed on a surface
or if it is tilted.
● Do not install or use the camera in the
following places.
• In a place exposed to rain or moisture.
• In a place with vapor or oil soot, for
example in a kitchen.
• In a temperature outside the operating
temperature range (–10°C to 50°C).
• Near a source of radiation, X-rays, strong
radio waves or magnetism.
• In a place subject to vibration.
• In a place with excessive dirt.
● If this camera and the cables connected
to this camera are used where there are
strong electromagnetic waves or where
there is magnetism present, for example
near a radio or TV transmitter, power
transformer or an electric motor, the picture
may produce noise and the colors may be
affected.
● This camera incorporates an AGC circuit.
As a result, when it is used under low light
conditions, the camera sensitivity is
automatically boosted and the picture may
look uneven. This is not a malfunction
however.
● The white balance setting when used
under a fluorescent lamp should be ATW
(Auto White).
● When this camera is used in the ATW
mode, the recorded colors may be slightly
different from the actual colors due to the
operational principles of the auto-tracking
white balance circuit. This is however not
a malfunction.