JVC SP-THS77C - Manual (Page 36)

Advanced operations
33
IMPORTANT
Before using the remote control for the following
operation;
• Set the remote control mode selector to AUDIO.
NOTE
Before you start operation;
• There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1
Press SETTING.
Example:
2
Press Cursor Y/5 to select the item
you want to set.
• DEC (Decode):
When you play an external source (DBS D is selected as a
source) that was encoded with DOLBY D or DTS Digital
Surround, the following symptoms may occur;
• No sound comes out at the beginning of playback.
• Noise comes out while searching for or skipping chapters
or tracks.
A/PCM (Auto/PCM):
Normally select this. The system
automatically detects the incoming signals.
DD: Select this if the symptoms above occur
when playing a disc (or software) encoded
with DOLBY D.
DTS: Select this if the symptoms above occur
when playing a disc (or software) encoded
with DTS Digital Surround.
• BAL (Balance):
You can adjust the balance between the front left and front
right speakers.
3
Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment is set and the display automatically disappears
a few seconds later.
NOTE
• When “DD” or “DTS” is selected, if a signal encoded with another
digital format comes in, you cannot listen to the sound. (The
G
DIGITAL or C indicator flashes.)
Sound and other settings
A E D / M C. C P
E D D D C.
See page 22 for button locations.
TH-S77[U].book Page 33 Wednesday, April 27, 2005 2:01 PM