JVC 0303MWMMDWJEM - Manual (Page 23)

20
English
Adjusting the Volume
You can adjust the volume level only while the unit is
turned on.
• The volume level has no effect on recording.
On the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
• When you press and hold each button, you can change
the volume level continuously.
On the main unit:
To increase the volume, turn VOLUME + / – control
clockwise.
To decrease the volume, turn VOLUME + / – control
counterclockwise.
• You can adjust the volume level within the range of
0 (silent) to 40 (maximum).
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; Otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
To turn down the volume level temporarily
On the remote control ONLY:
Press FADE MUTING.
The volume level gradually decreases to “VOLUME 0.”
To restore the sound, press FADE MUTING again.
• Turning VOLUME + / – control clockwise (to +) on the
unit or pressing VOLUME + on the remote control also
restores the sound.
Selecting the Sources and Starting Play
To select the tuner as the source, press FM/AM.
The unit automatically turns on (when the unit is in
standby), and the last selected band appears in the main
display.
• Each time you press the button, the band alternates
between FM and AM.
• For more detailed operations, see pages 24 to 26.
To select the DVD player as the source, press DVD
SELECT
3 (or DVD #¥8 on the main unit).
The unit automatically turns on (when the unit is in
standby), and “READING” appears in the main display for
a while.
• Play will start if a disc is in the disc tray.
• “NO DISC” will appear in the main display if a disc is
not loaded.
To stop playback, press
7.
• For more detailed operations, see pages 27 to 39, 42 to 48.
To select the tape as the source, press TAPE
2 3.
The unit automatically turns on (when the unit is in
standby), and “TAPE” appears in the main display.
• Play will start if a tape is in the cassette holder.
To stop playback, press
7.
• For more detailed operations, see pages 40 and 41.
To listen to the sound from external equipment, press
AUX/MD.
The unit automatically turns on (when the unit is in
standby), and “AUX/MD” appears in the main display.
• For operating external equipment, see its manual also.
When changing from another source to “AUX/MD”
If the sound from the component connected to the AUX/MD jacks
is too loud or is not loud enough (without changing the volume
level), you can change the audio input level through the AUX/MD
jacks. (See page 23.)
EN18_23UX_A7DVD[UF].pm6 03.2.26, 9:25 PM 20